this post was submitted on 29 Oct 2024
83 points (98.8% liked)

Linux

5321 readers
201 users here now

A community for everything relating to the linux operating system

Also check out [email protected]

Original icon base courtesy of [email protected] and The GIMP

founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 5 points 3 weeks ago (2 children)

This'll be my first Silverblue major version update. What am I in for?

[–] [email protected] 4 points 3 weeks ago (1 children)
[–] [email protected] 2 points 3 weeks ago (1 children)

The upgrade turned out to be extremely uneventful!

[–] [email protected] 2 points 3 weeks ago

For me my display was automatically set to 150% scaling for some unknown reason. I changed it to 100% and everything was fine.

[–] [email protected] 2 points 3 weeks ago (2 children)

I just did it. You're in for a reboot. That's about it, unless you layered a bunch of stuff.

[–] [email protected] 2 points 3 weeks ago (1 children)

It won't matter of you layered a bunch of stuff

[–] [email protected] 1 points 3 weeks ago (1 children)

It will if the repos are specific to a fedora release version. That's been a thing with rpmfusion in the past, not sure it still is.

[–] [email protected] 1 points 3 weeks ago

If you are using the officially supported repos you are fine. If are not using official repos I would strongly suggest that you do.

Any external software should be installed in a container (ideally) or in a VM.

[–] [email protected] 2 points 3 weeks ago (1 children)

I maaaay have layered some stuff that I couldn't find flatpaks for. 🥺

[–] [email protected] 3 points 3 weeks ago (1 children)

I used to have issues with like rpmfusion repos and the like, worst case you may need to now the packages you have layered, do an rpm-ostree reset, upgrade, then layer the packages again. There's a way to install the rpmfusion repos that didn't break updates, I forget if they've updated the docs on the site to use it, I stopped layering almost everything in favor of flatpak or toolbx.

[–] [email protected] 2 points 3 weeks ago

I'll keep your advice in mind. Thanks kind internet stranger. ✌🏻