neidu2

I have a Dell Latitude 5420 laptop with LMDE, running kernel 6.1.0-12. This laptop has a builtin I219-LM ethernet controller that I can see via lspci. Some research indicates that this needs the e1000e kernel module, so I grabbed it from Intel, compiled it, and installed it. There were some complaints during the compilation, but nothing more than the average compilation process. Plus, it shows up in lsmod. Afterwards, lspci -vv displays it with the e1000e driver:

0000:00:1f.6 Ethernet controller: Intel Corporation Ethernet Connection (13) I219-LM (rev 20)
        Subsystem: Dell Ethernet Connection (13) I219-LM
        Control: I/O- Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
        Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
        Interrupt: pin A routed to IRQ 16
        IOMMU group: 15
        Region 0: Memory at a6100000 (32-bit, non-prefetchable) [size=128K]
        Capabilities: [c8] Power Management version 3
                Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
                Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=1 PME-
        Capabilities: [d0] MSI: Enable- Count=1/1 Maskable- 64bit+
                Address: 0000000000000000  Data: 0000
        Kernel modules: e1000e

However, when I do lshw, it is listed as unclaimed:

  *-network:1 UNCLAIMED  
       description: Ethernet controller  
       product: Ethernet Connection (13) I219-LM  
       vendor: Intel Corporation  
       physical id: 1f.6  
       bus info: pci@0000:00:1f.6  
       version: 20  
       width: 32 bits  
       clock: 33MHz  
       capabilities: pm msi cap_list  
       configuration: latency=0  
       resources: memory:a6100000-a611ffff  

...and of course, it's still not showing in ifconfig. So, where do I go from here? Did I miss anything obvious?

And just for the record, I know that the ethernet port is working. It worked fine in Win11 before wiped the PC completely.

....to a reasonable degree, at least.

A couple of others I can think of:

• Crypto-boom of 2016ish: GPUs/mining rigs
• LLM/AI hype nowish: User generated data
• 90's dotcom bubble: Server space

Title, basically. My old torture device needs to be replaced, and while it's been mostly working OK, printers have no excuse for being as shitty as they are. So therefore I am looking for suggestions.

Specs:

• Must include a flatbed scanner
• prints in color
• Wifi connection preferred
• No PaaS or IaaS bullshit
• No driver weirdness. I'm going to use it on linux.
• Available "anywhere".
• Ability to sit powered and connected in my HarryPotteresque "server room" under the stairs for ages, unattended, and work without hazzle when I send it the bimonthly print job.

I know the geek community likes Brother. Any particular model?

For reference, this new printer will replace my aging Canon Pixma 4250.

Turns out Outlook sucks ass for anything not part of an office365 subscription, so I'm looking for something else. Preferably open source, preferably available via F-Droid.

One example I've seen is someone talking about being coconut-pilled.

Basically what the title says. Here's the thing: address exhaustion is a solved problem. NAT already took care of this via RFC 1631. While initially presented as a temporary fix, anyone who thinks it's going anywhere at this point is simply wrong. Something might replace IPv4 as the default at some point, but it's not going to be IPv6.

And then there are the downsides of IPv6:

• Not all legacy equipment likes IPv6. Yes, there's a lot of it out there.
• "Nobody" remembers an IPv6 address. I know my IPv4 address, and I'm sure many others do too. Do you know your IPv6 address, though?
• Everything already supports IPv4
• For IPv6 to fully replace IPv4, practically everything needs to move over. De facto standards don't change very easily. There's a reason why QWERTY keyboards, ASCII character tables, and E-mail are still around, despite alternatives technically being "better".
• Dealing with dual network stacks in the interim is annoying.

Sure, IPv6 is nice and all. But as an addition rather than as a replacement. I've disabled it by default for the past 10 years, as it tends to clutter up my ifconfig overview, and I've had no ill effects.

Source: Network engineer.

....så det så

Controversial hot take, I know... but in certain cases, normalcy and routine is the desired state. After a long weekend of family events, too many kids (of which most are my own), too many pets (of which roughly half are my own), and the house being drafty with the entire in-law clan and then some for the past few days, things are now finally back to normal.

Kids are in school, SO at work, and I'm in my home "office" (I use my bedroom), arranging the coming week. I schedule most things to "ot today" because now it's MY time. When picking up some supplies this morning I even bought one single beer that is for my lunch, and beyond that my work day will mostly be centered around waiting for various balls that are in other people's courts.

Anyone else who usually welcome mondays when they arrive?

...and I don't know which possibility is the least worrying

cross-posted from: https://feddit.nl/post/13434122

What are some interesting communities on Matrix worth checking out?

Title, pretty much. I'm in a couple of niche communities, and thought I should expa d into more generalized communities. All things tech are of interest, really.

Which communities are you in?