Forestial

joined 1 year ago
[–] [email protected] 6 points 3 weeks ago

Enjoyed the little slow-motion right before impact

[–] [email protected] 4 points 3 weeks ago

It’s bad for sure, but better than said resources being used to kill Ukrainians

[–] [email protected] 1 points 1 month ago (1 children)

There used (1970s maybe) to be a brand called Camp in the UK which I think was a blend of coffee and chicory as a liquid that you added hot water to. Awful stuff as I remember it. It may still be sold there for all I know.

[–] [email protected] 19 points 1 month ago (1 children)

Famine! Pestilence! Locusts for sure!

What an idiot.

[–] [email protected] 1 points 3 months ago

Thanks. I have hplip installed on my Pi (version 3.21.2) and my printer is listed as being supported on the hplip support page. That page says Support Level is "Full" and Connectivity is "USB, Network". So it seems that this should work; also the printer works fine over USB to my Windows laptops.

hplip seems to provide a number of command line commands with names like hp-probe and hp-firmware. I have not been able to get any of them to work over USB though; usually they return a message "Warning: No devices found on the 'usb' bus".

Do you mean that "proprietary firmware" is needed to make the printer work with Linux?

[–] [email protected] 3 points 3 months ago (1 children)

Why? Just Why?

[–] [email protected] 3 points 3 months ago (2 children)

Good work. I tried to do similarly with a HP CP1025nw (roughly 10 years old), which has become unreliable with Windows 11. But although I connected the printer to the Pi (I used a model 3B) with a USB cable, CUPS does not appear to see the "usb://....." connection string. CUPS does allow me to connect to the printer wirelessly, with a connection string that begins "dnssd://....".

So I have it working wirelessly but I was hoping to get it using USB since I suspect that would be more reliable.

I'm wondering why your Pi allows the "usb://....." method, but mine does not.

[–] [email protected] 6 points 4 months ago
[–] [email protected] 33 points 4 months ago (6 children)

This may be a ploy for Trump to avoid the debates, since he knows he's likely to lose as in 2020. Biden refuses the drug test, Trump then refuses to debate....

[–] [email protected] 2 points 4 months ago
[–] [email protected] 5 points 5 months ago

Quite a run. I didn’t know Zilog was even still in existence under the same name, albeit part of a bigger company. Still remember learning assembler on a TRS-80 Model II with one of these in it.

[–] [email protected] 18 points 5 months ago

I find that there is far too much of it in my Lemmy feed. I have a very long list of blocked communities which I have blocked, tediously, one at a time as they appeared. Obviously a lot of people like it, but it’s not for me.

I wish there was a setting similar to the one that blocks NSFW content, but for anime and manga.

view more: next ›