this post was submitted on 19 Feb 2024
6 points (100.0% liked)
VoronDesign
305 readers
7 users here now
lemmy.world community for VoronDesign 3D printers
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I have a 230mm bed slinger already, but wanted something for ABS/ASA, which will probably be printing smaller parts mostly, so the 120mm is OK for that. I kind of just wanted to get rid of the other printer so I still only had one, but the 120mm build plate of the V0 makes that a bit hard.
For ABS/ASA, a V0 will likely be less frustrating. Larger ASA/ABS prints in a big printer invite warping for two main reasons. The first is just basic physics, larger parts have more material for tension to build in so they'll be more likely to warp. The second is chamber temperature. By their nature, smaller printers will have smaller enclosures with less surface area, which means you'll be able to get it toasty in there with less effort/modification. My 350 with just the filter installed and the stock 3mm acrylic panels struggles to get much above 40-45° C in my 65° F basement - even after soaking for two hours. I'm aiming to bump my chamber temp another 20° C to reduce/eliminate warping, but that's likely going to require a decent amount of modification.
Hmm, that's a good point I didn't consider. I didn't think the larger printers were struggling that much maintaining higher chamber temps.
It's a lot of volume and a lot more area for loses. You're only really heating the chamber with a what a 750 W heater to heat the build plate, by default you're only getting natural convection and radiation to heat the interior, bed fans help and so does something that recirculates the air in the chamber. I generally don't have issues with abs on my 350 mm v2 but larger, less substantial prints will have issues, I'm dropping some extra bed fans in when I do some upgrades this week which should help me get higher temps