Mpatch

Yeah for the unlucky some of us when a cramp hits, nothing helped. Fuck I've even tried running up and down stairs at 3am. Doing full stretches etc. Turns out good chance you're low on magnesium or potassium or maybe Manganese? I don't remember but the wife shoves one of the 3 in my mouth when she's had enough of my whining and I'm good for a while with no cramps at night.

Yeesh that sucks. Least you have coffey snaks for days to come. I move to my place like 6--7 years ago and I'd be lucky to get through a small box of chocolate. Each year it picked up to the point where this year I had 2 full size bars left from the 50 I started with.

This to shall pass, a grind?

Gifs that end to soon

Nah my cast only washes with hot water and small Scraper. If you need soap. We'll you don't like actualy don't. Seasoning? Just cook bacon, dump the grease leave a bit in put it back on the stove for a hot minute or while you put your blt together. Done it's hunk of metal not much you can do to fuck it up. And if food is sticking to it probably cause you didn't get the pan hot enough before you put the food in.

Oy yah i Rember the Repunzle tutorial.

I've been using a 1/4" thick sheet of carbon fiber for years now. Once warmed up to temp prints stick hard on it. As soon as it's cool a breeze can push a print of the bed. Plus it won't shatter like glass does eventually, boy was that a surprise. You still have to wipe clean with some rubbing alcohol before printing.

Bad bearing on a moving part. Or a bur along a rail, It catches just enough to cause the smooth motion to jitter a bit as the head moves along. Blobbing the material down instead of spreading it nice and even.

You have a draft going through your room, I used to have same issue when my printer was beside a window. Less when I moved the printer to middle of the room and issue was gone when put the printer into a closet. With closed doors.

You can try lowering bed temperature to, the warm bed keeps lower layer pliable but the upper layers cool and contract pulling the more flexible layer up and away. So a cooler bed temp should make the bottom layers more ridgid.

You are a fucking monster. The point of this was to have some laughs not cause a poor walmart employee to beat their spouse or off them selves. Damn you're cruel.