Ask Electronics

3173 readers

2 users here now

For questions about component-level electronic circuits, tools and equipment.

Rules

1: Be nice.

2: Be on-topic (eg: Electronic, not electrical).

3: No commercial stuff, buying, selling or valuations.

4: Be safe.

founded 1 year ago

MODERATORS

[email protected]

Microvawe transformer spotwelder. Is there a way to improve it? (lemmy.dbzer0.com)

submitted 11 months ago by [email protected] to c/[email protected]

18 comments fedilink hide all child comments

Hi, I have built a microvawe transformer spotwelder, I have put a single turn of welder wire for in the secondary and I'm timing it with arduino. Worth mentioning it was/is a 230V transformer. Electrodes are sharpened copper rods. I believe the voltage is still high. The spotwelds it produces are slightly discolored and not as strong as you would expect. Is this design fundamentally borked? Is there anything else I can make to make it better? Photo from test stage before it was built into a project box, it is less "shocking" now.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 11 months ago (1 children)

Where is the video? Electroboom craziness sounds entertaining.

[–] [email protected] 2 points 11 months ago

https://www.youtube.com/watch?v=K_pD0W_Fm6g

He burnt himself off a 12v battery. Increase the voltage by the amount you want to live dangerously at the benefit of getting better weld. It also suggests using two MCBs in series in case one of them does not trip for any reason.