Home Improvement

8910 readers

1 users here now

Home Improvement

founded 1 year ago

MODERATORS

[email protected]

nieceandtows

Handyman is asking $500 to sand and fill the rot with putty, caulk and paint the door. Is that a fair ask? (NC) (album with multiple photos) (imgur.com)

submitted 11 months ago by [email protected] to c/[email protected]

19 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 47 points 11 months ago* (last edited 11 months ago) (2 children)

You can get a new door and frame installed for about the same cost. Once rot sets in, it has to be cut out completely which then further compromises the frame. Putty, caulk, and paint will just slow down the inevitable.

If you want it done right I'd go ahead and find another handyman who can hang a new door. It's not a terribly difficult job but steps have to be taken to keep water from ruining the new door frame, it needs to be leveled, etc.

EDIT to add - is this a single door or a French door? I can't quite tell by the pictures you shared. If it is indeed a French door then the cost will be quite a bit higher.

[–] [email protected] 12 points 11 months ago (2 children)

You can get a new door and frame installed for about the same cost.

I know cost of living differs, but I find it hard to believe you can get someone to buy and hang a door for $500. Gut check for me would be at least $1000, probably closer to $2k. Maybe 20 years ago you could get that for $500

[–] [email protected] 4 points 11 months ago (1 children)

I just spoke to somebody who asks $2200 labor and $1800 materials for a new door/frame

[–] [email protected] 2 points 11 months ago

Yeah, that sounds much more like what I would have guessed.

[–] [email protected] 2 points 11 months ago (1 children)

They are standardized so it does not take long. One worker can easily do it in a day. But that day rate + travel is going to vary widely by location. I could get it done for $300 labor here in rural America. Plus the cost of the frame.

[–] [email protected] 4 points 11 months ago

Rot doesn't necessarily need to be cut out. There are epoxy products that will wick into the fibers and strengthen them, and then epoxy putties that can be used over the top prior to painting, which will also have the side benefit of being more resistant to rot than wood. I'm not sure that I would use those products in this case though; replacing the frame would probably be less of a hassle.