this post was submitted on 13 Nov 2024
245 points (93.3% liked)
Asklemmy
44178 readers
1520 users here now
A loosely moderated place to ask open-ended questions
Search asklemmy π
If your post meets the following criteria, it's welcome here!
- Open-ended question
- Not offensive: at this point, we do not have the bandwidth to moderate overtly political discussions. Assume best intent and be excellent to each other.
- Not regarding using or support for Lemmy: context, see the list of support communities and tools for finding communities below
- Not ad nauseam inducing: please make sure it is a question that would be new to most members
- An actual topic of discussion
Looking for support?
Looking for a community?
- Lemmyverse: community search
- sub.rehab: maps old subreddits to fediverse options, marks official as such
- [email protected]: a community for finding communities
~Icon~ ~by~ ~@Double_[email protected]~
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The voxelab aquila "knockoff ender 3" 3d printers.
At this point, I'd also just say Ender 3 printers. You can get them for a hundred bucks now. They're not as fancy as the newer 3d printers with auto-leveling, remote printing, dual extruders, etc. But they get the job done just fine.
My Ender3v2 always has some new problem to deal with. Itβs cheap but itβs a pain in the ass.
Interesting, I have the opposite experience. Even with my half assed tinkering it prints just fine. Slow but fine.