Are you addicted to the clicking sounds of your beautiful and impressive mechanical keyboard?
If so, this community is for you!
Here you can discuss everything about mechanical keyboards (and only mechanical keyboards).
Banner by Jay Zhang on Unsplash
More pics at GH starting HERE.
When I had xometry cut my plate for the one in the back, it was pretty cheap to have them cut three sets compared to one. Tried a few different ideas on build two. Tactile switches, "CSA" keycaps, 3D printed sides at 3-degree incline, and springs supporting the middle of the plate. This one is pretty flexy, but still feels secure. I don't think it's going to replace my clicky boi full of Box Navies though.
I like the wood spacer. What did you use for that?
It’s small pieces of solid wood from a mystery box of mostly lathe turning blanks. Pretty sure it’s just red oak, but that fits the vaguely 80s vibe on that build perfectly. I trimmed them to size on my table saw and jointer, but I may eventually redo them, as the fitment (on both boards actually) is just a bit off.