this post was submitted on 20 Jun 2024
20 points (91.7% liked)

Framework Laptop Community

2632 readers
6 users here now

Related links:

Related communities:

founded 3 years ago
MODERATORS
[email protected]
uthredii
20
Bent RAM Clip (infosec.pub)
submitted 4 months ago by [email protected] to c/[email protected]
6 comments fedilink hide all child comments
 

I've somehow managed to bend a RAM clip so it can't clip anymore because it's blocking itself. I haven't been able to bend it back. Any suggestions?

top 6 comments
sorted by: hot top controversial new old
[–] pezmaker 10 points 4 months ago

I don't know if this explanation will help because words. Using the photo plane as reference:

Two tools, a flat head screw driver wider than the vertical gap where the hook is, and a needle nose pliers. The screwdriver is going to be used to try to rotate the hook to the bottom left to clear the horizontal metal band, while squeezing the two bars midway to help bring the hook tip past the horizontal bar

[–] [email protected] 4 points 4 months ago

Duck tape? Could also try pinching the piece with needle nose pliers right at the bend.

[–] [email protected] 1 points 4 months ago (1 children)

It looks like it's supposed to block it from going the other direction. So, maybe gently try to lift it over to the blocking tab?

[–] [email protected] 1 points 4 months ago

It strongly resists going up; I wasn't able to do it that way.

[–] [email protected] 1 points 4 months ago

Twist it so it goes around from the side instead of above? It managed to pass it before somehow to get to this position.

[–] [email protected] 1 points 3 months ago

You could try to heat it a bit with a hair dryer or something, maybe that makes bending it a bit easier, I'm not sure. Just be careful to not heat up any surrounding chips too much.