Do-It-Yourself, Repairs and Fixes

2652 readers

1 users here now

Share tips and tricks to keep people from throwing out that broken item. Repair before replace!

founded 5 years ago

MODERATORS

[email protected]

Is this normal? I repaired a DW745 Table Saw (youtu.be)

submitted 6 months ago* (last edited 6 months ago) by [email protected] to c/[email protected]

0 comments fedilink hide all child comments

cross-posted from: https://mander.xyz/post/12406051

I'm not sure where the right place to post this would be, but here goes.

I bought this DW745 Type 2 saw off of Facebook Marketplace. I think it was abused. I replaced both of the elevating shafts (5140100-04 & 5140100-05). I also had to replace both of the bevel gears (5140061-65).

The aluminum housing seems to be okay and the lifting shafts move in and out without much resistance. I'm still getting this chunky movement when I raise and lower the blade.

I'm looking for advice before I go though the whole process of replacing the entire aluminum housing on the motor.

no comments (yet)

sorted by: hot top controversial new old

there doesn't seem to be anything here