this post was submitted on 16 May 2024
98 points (74.5% liked)
Memes
45662 readers
1561 users here now
Rules:
- Be civil and nice.
- Try not to excessively repost, as a rule of thumb, wait at least 2 months to do it if you have to.
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
You do you boo but Metrics fucking awesome. It's simple, conversions are super easy, etc. it's just basic numbers. You can thoughtlessly multiply or divide (assuming you could thoughtlessly do that before).
You want a real shite headache? Try translating tenths of inches. I'd just burn the blueprints and tell them to try again.
OP was being sarcastic.
Serious question about this argument. Try translating tenths of inches... to what? I assume you're not talking about converting to metric because then any unit is problematic, and if you're using tenths of an inch then you're using inches, not something else, so... what's the problem?
The most common place to find .1" is on micrometers. And that's just fine until you need to switch it back to imperial or metric for the next processing...which the rest of your tooling is in.
.1" is roughly 2.54mm
.1", fractionally is ~7/64
7/64 is roughly 2.77mm
See how this is recipe for disaster?