I just retrofitted my basic hand crank mill with a 10mm nut, and drove it with a drill. It's so much faster now, but I do wonder if there's actual properly motorized versions of what I just did.
this post was submitted on 06 Apr 2024
198 points (95.4% liked)
Coffee
8459 readers
1 users here now
☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Capresso Infinity. It is an inexpensive conical burr grinder. I bought mine in 2012.
Mine lasted about 4 years before the thermister died. I replaced it with a 1Ω resistor and it works no problem. I've had to replace that resistor about every 4 years, three times so far, most recently a couple months ago. I would guess it is there to limit heat in the motor but the motor has not yet failed so 🤷.
I grind 60g of medium fine or 40g of coarse just about daily and it has otherwise held up fine. In the summer for the last few years I grind 120g of coarse every few days for cold brew, that is a longer grind and probably the most risk of overheating but hasn't really affected the life AFAICT.
You may be able to spend more on a grinder that lasts more than 4 years, but this is a cheap and easy fix if you're handy with a soldering iron.