I just retrofitted my basic hand crank mill with a 10mm nut, and drove it with a drill. It's so much faster now, but I do wonder if there's actual properly motorized versions of what I just did.
this post was submitted on 06 Apr 2024
198 points (95.4% liked)
Coffee
8459 readers
1 users here now
☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
The Hario burr grinder in the OP is not on the same level. The one I had was about $40, and was so slow to grind that the drill was a gigantic upgrade. It cost me $.50 in parts to use with a drill I already had, which was great for college me. Cost was the deciding factor.
That's cool then. I'm all for cost saving measures, especially for niche stuff like this which seems to always be overpriced.
And yet the Skerton is still a terrible grinder. Not much better than a blade grinder. Too much boulders and dust. Grind uniformity is just plain bad.
I agree. Glad I got rid of it.