I just retrofitted my basic hand crank mill with a 10mm nut, and drove it with a drill. It's so much faster now, but I do wonder if there's actual properly motorized versions of what I just did.
this post was submitted on 06 Apr 2024
198 points (95.4% liked)
Coffee
8459 readers
1 users here now
☕ - The hot beverage that powers the world!
Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!
Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I did that with mine. But I found that I had to feather the drill a lot to keep the grind consistent.
Eventually I just went back to buying pre ground.
Edit: actually I think I have the pro version of yours. Ended up buying a steel ring to go between the mill to stabilize the central steel pin. Got a more consistent grind after it. But felt I needed to keep the drill at a lower speed.
This sound!! I recognise this sound! Do you hear it? It‘s the doppler effect of pitchforks being dragged over the pavement.