this post was submitted on 26 Mar 2024
637 points (96.6% liked)

linuxmemes

20880 readers
7 users here now

I use Arch btw


Sister communities:

Community rules

  1. Follow the site-wide rules and code of conduct
  2. Be civil
  3. Post Linux-related content
  4. No recent reposts

Please report posts and comments that break these rules!

founded 1 year ago
MODERATORS
 
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 5 points 8 months ago* (last edited 8 months ago)

I've generally had good luck with hardware and things just worked under linux. But one day I upgraded a few machines on my network to 2.5G ethernet. Several already had the ports, but my little NUC NAS box didn't, so I installed a 2.5G usb ethernet dongle. No matter what I did, I couldn't get it to work. It would show up and NM would act like it was up and there were no errors or anything, but it just wouldn't actually function.

Eventually, I found out that it has a built in USB data partition that contains the drivers for windows. The card was coming up as a usb disk first when the hardware was assigned and not a network card which it should have been.

I had to write a blacklist the usb modules first, which I had done before, but I had to also write a udev rule to automatically add the network card and driver on boot. It wasn't that difficult to actually do, but I had just never had to do anything with udev rules before. Took me a good three days of troubleshooting to finally get everything to work correctly on boot.

ACTION=="add", ATTRS{idVendor}=="20f4", ATTRS{idProduct}=="e02c", RUN+="/sbin/modprobe r8152" RUN+="/bin/sh -c 'echo 20f4 e02c > /sys/bus/usb/drivers/r8152/new_id'"