Hey,
Still fairly new to this hobby and have lots of ideas but I've got a snag with a few prints now and was hoping someone could help me work out what I'm doing wrong.
The project is small trays for a custom advent calendar but as you can see the corner on the second picture has lifted massively.
This has happened before with a different print too and I never solved that issue either.
Using an Ender 3 Pro with some generic filament from amazon, hot end at 200C (goes stringy any higher), bed was 50C for this print I think.
Any help would be wonderful :)
Other recommendations are great but you could also try some type of adhesive AFTER you've eliminated any other potential problem sources.
It does look a over extruded. Have you calibrated your esteps? I always need to do that when changing filament types and sometimes even between rolls of the same filament type (especially bargain bin PLA from amzn)
My ender 3 with a textured glass bed sticks perfect with PLA and nothing else. For some reason PLA+ tends to lift. Glue stick helped with PLA+ but I hated dealing with because it REALLY stuck so I switched to masking tape. That does the job and is easier to remove. On my CR-10 with plain glass bed (no texture) I use hairspray... Mostly because that's what the guy I bought it from recommended and, to be honest, it does work amazingly. Nothing sticks to that glass plate bed without an adhesive but it pops right off once the bed cools down.
That said, I don't recommend "extra" adhesives unless you're fully sure you've solved any other potential problems. They can be a help/bandaid but if the root cause is something else then you're just masking it.
Some materials and beds need some help, some don't. I primarily use PLA and PLA+ with the occasional PETG and TPU.
Useful insight, I'll try the other suggestions before an extra adhesive though! I still need to get my head around printer settings again as I've not used this for a couple of years and my brain has decided to forget that info for other useless things instead.