this post was submitted on 03 Feb 2024
12 points (100.0% liked)

3D Printing

4371 readers
1 users here now

For everyhting 3D printing related.

Please be excellent to each other :)

Icon by Freepik, Banner photo by Thiago Medeiros Araujo

founded 4 years ago
MODERATORS
12
Cutting Garolite (G10) (self.3dprinting)
submitted 9 months ago* (last edited 9 months ago) by CameronDev to c/[email protected]
 

I posted here a while back when my glass bed failed. One of the suggestions was to replace with Garolite or G10. My sheet finally arrived and i set about cutting it down to size.

...

Within 4cm, my basically unused jigsaw blade was worn flat, and by the end of the first cut (20cm), there is basically no more teeth.

For the second side, I tried using a multitool cutter, and within a few millimeters it was visibly blunt (plastic and metal tools). Finished it off with a standard wood hand saw, which seemed to go better.

So warning to anyone considering garolite, dont use power tools, it will fuck them up.

you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 2 points 9 months ago* (last edited 9 months ago)

I used tungsten carbide end mill bits, 4 fluted, at low depth of cut and low feed rate but about 800 rpm, on a mill