this post was submitted on 12 Dec 2023
16 points (100.0% liked)
Ask Electronics
3325 readers
1 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Would a circuit like this power-on reset circuit work for your application?
Im sorry, noob here. I don't know what the voltage at the reset pin would be when the capacitor is discharged, my first guess would be 0v but the answers there say it's the reverse - VCC at power on, then goes to gnd as it charges.
If that's the case, I think it's exactly what I need.
I'll test it out later today (and I'll go read more about how this capacitor+resistance circuit works...).
As you said before power on capacitor is discharged. Right after power on capacitor is still discharged, so voltage on capacitor is zero, so reset pin has Vcc. With time capacitor gets charges and voltage across capacitor increases and reset voltage becomes closer and closer to ground, until it is ground. But it is important to consider what happens at power down too. At power down capacitor is charged. If power source becomes high impedance at power down, then reset pin will probably go down to zero in time but may take a bit time depending on what source exactly does. But if power source is connected to zero at power down reset pin will observe minus vcc and slowly go up to 0. If reset pin is sensitive it may be a good idea to protect it with a diode.