196

16512 readers

2480 users here now

Be sure to follow the rule before you head out.

Rule: You must post before you leave.

^other^ ^rules^

founded 1 year ago

MODERATORS

[email protected]

1418

Cyan Low, Rule (slrpnk.net)

submitted 1 year ago by [email protected] to c/[email protected]

106 comments fedilink hide all child comments

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 3 points 1 year ago* (last edited 1 year ago) (1 children)

Just do a midprint filament swap... Looking at getting into TPU at the moment, it might actually be a fun way to have my kid hand something short in. 3 layers of white, 0.12mm per layer, swap to black and print 3 layers more. I'd be concerned about stringing and delamination. But it's pretty close to the heated bed, so mostly stringing. Fuckit we're going to try!

[–] [email protected] 2 points 1 year ago (1 children)

Your now going to do this and report back right?

[–] [email protected] 1 points 1 year ago (1 children)

Actually, I was going to yesterday. But I will try to get to it this weekend. Am becoming a bit worried about warping though...

[–] [email protected] 1 points 1 year ago

Engineering Method my friend