Hello!
I've been scratching a design for my new keyboard and wanted to try something fun. It's gonna be a 34-key unibody split, but I thought it would be cool to use the space in the middle for something fun. Many parts like cirque touchpads, roller encoders and such are hard to obtain in my area, so I didn't bother. Then I found a post by LazaroFilm with a small smartwatch LCD made by WaveShare and thought it would be a fun idea. I browsed their catalogue and noticed that none of the models are ideal for the job. The RP2040 touch LCD lacks GPIO and mounting points, the RP2040 LCD is pretty cool, but not having touch support is a bummer. Finally I thought that maybe it's better to go with a separate controller like a pico, and an 1.28" Round Touch LCD. It has touch support (duh) and 4 mounting screw posts. Pretty good. My only issue is the 13 pin JST connector used to hook it up to an MCU. It's gonna be a PCB design, no hand wiring, so I don't want a mess of cables dangling around. If only I was able to hook up a goldpin connector, or something, it would come together pretty clean. I was toying around with an idea of designing an adapter board, but there's not much room to play with and the pins are pretty tightly spaced (1.25mm). Also, it would be really great to come up with something that can be easily done without special equipment. All I have is a soldering station. No hot air, no nothing. I'd love to be able to design something that anyone can make at their desk.
I'd be grateful for any clever ideas. Thanks in advance! Cheers!
This is my CyberLevel project that uses the same module. You can see the way I mounted the screen my catching the edges of the screen and clamping it down to the case. In the case are small cutouts that allows the PCB to lean on without touching components.
https://imgur.com/a/u1HeqRa