this post was submitted on 25 Jun 2023
56 points (100.0% liked)
RetroGaming
19213 readers
1 users here now
Vintage gaming community.
Rules:
- Be kind.
- No spam or soliciting for money.
- No racism or other bigotry allowed.
- Obviously nothing illegal.
If you see these please report them.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I did it without a jig. It was early days and I used a paperclip to manually bridge the pins. As long as you're careful it's actually pretty safe. Just push it towards pin 9 and 10, and it should work.
I've also seen people mod their joycons to make the button you push to slide the joycon into a RCM button, which I might do.
In any case, just don't jam anything in willy-nilly and it shouldn't break. Same with the jig. You can set the switch to automatically go into RCM mode as well once the modding is done, removing the need for the jig, although the switch will then not boot normally when you don't have a payload for it. The only time this happens realistically is when the battery depletes.