3DPrinting

15651 readers

167 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: [email protected] or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

Klipper and Ender5+ are kicking my ass (partizle.com)

submitted 1 year ago by [email protected] to c/[email protected]

11 comments fedilink hide all child comments

I'll start out saying, i'm not very good with this stuff.... I have an Ender 5+.
I had it setup with octoprint and klipper from a guide I found a couple years ago, and it worked OK for me to get klipper installed, working on octoprint, and pressure advance tuned ok ish.

Recently my SD Card became corrupt, and like an idiot I didn't have anything backed up.

So I'm trying to setup the system again from less than scratch and it's kicking my ass.

I've decided i'd like to try Mainsail, as it's interface looks interesting (no other reason) But I can't for the life of me get it working.

EVERY guide I try and follow seems to fail on the connect between klipper and the printer.

I can flash the klipper firmware successfully, and have updated the port ID in the printer.cfg file, but it always comes back to klipper not being able to see/access the port.

Any help would be appreciated here.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 1 points 1 year ago

Thank you for pointing me in the right direction.

Pi Imager lets you option for a username change. I changed it originally, and mainsail is setup for "pi" user normally.

I reflashed with pi Imager, without changing username, and it all is working now.