12
How to properly size a serial bulb for protection when troubleshooting a circuit?
(discuss.tchncs.de)
this post was submitted on 18 Jun 2023
12 points (100.0% liked)
Ask Electronics
3325 readers
1 users here now
For questions about component-level electronic circuits, tools and equipment.
Rules
1: Be nice.
2: Be on-topic (eg: Electronic, not electrical).
3: No commercial stuff, buying, selling or valuations.
4: Be safe.
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
For this application you should be using a bench power supply with current limiting, not a "serial bulb" (I assume you mean a fuse, which is designed to break at a low current, however these are most typically rated for several amps, not typically in the mA range). You can set the voltage and a current limit. If the current goes beyond the limit, then the power supply will drop the voltage to keep the current below the limit or latch off. You can get a fairly cheap one for about $50-60 off of eBay, which won't be the best but is sufficient for hobby use
Hey, thanks for your reply. By serial bulb I mean a incandescent lamp in series with the circuit. I was looking for a cheap and diy option, but I'll take a look on a bench power supply. I still need to get me a decent one anyways.
Ah. It's not going to be possible to size it because the bulb is then acting as a resistor essentially. Unless you know what the equivalent resistance of the circuit you're testing is, and it draws a fixed current, you aren't going to be able to cap the current; Adding a resistor (or bulb) is just going to drop the input voltage and you will probably end up having other issues
And the bulb is a strange resistor, it has a really high current when starting up cold. This can fry everything behind it.
It has the high current because it's cold, it only needs a short time to heat up and light up and the majority of circuits can handle very short overcurrent really well because the connections need to heat up before they break. Using a lightbulb for current limiting works pretty well.
Ah got it. Then a bench power supply is the way to go. Thanks again!