I'd sincerely recommend everyone to read his manifesto and think about it a little bit.
this post was submitted on 20 Dec 2024
674 points (96.5% liked)
196
16719 readers
2530 users here now
Be sure to follow the rule before you head out.
Rule: You must post before you leave.
founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Important to note: 3D PRINTED FIREARMS DO NOT BREAK WITH A FEW USES
Firsthand knowledge.
200-250 rounds and still going strong, inspected before and after firing every time
No damage so far.
Beyond that point, I agree with everything posted.
Yeah 3d printed gun is such a misnomer for most of the "ghost guns", the gun he had was just the printed frame. That section of the 3d printing community isn't really my scene but that seems to be what I've seen for all the printed guns, lower/frame with barrel and trigger assembly being metal pieces. I think years ago I saw a modern reinterpreting of the WW2 Liberator that was done in all plastic but that's obviously designed to shoot only once.
I'm sure you know more about the scene than I do and can correct or verify my knowledge.
The ones I have use 3d printed frames, the fire control group and barrels are metal with 3d printed pieces for making the rifling.
All the parts that take repeated heavy abuse are reinforced with extra thickness or different infil, but by weight I'd say it's about 50/50 metal/plastic.
The 3d printed lowers are quite basic, and since they aren't designed to take a ton of stress anyway, it's not really hard to find a decent design.
All my parts are printed in pla+, and I do minimal work afterwards to make things perfect, only what is necessary for the mechanical parts to cycle properly.
I actually haven't been keeping up the last few years, I wouldn't be surprised if there are even better methods than the ones I've used.