3DPrinting

15787 readers

219 users here now

3DPrinting is a place where makers of all skill levels and walks of life can learn about and discuss 3D printing and development of 3D printed parts and devices.

The r/functionalprint community is now located at: or [email protected]

There are CAD communities available at: [email protected] or [email protected]

Rules

No bigotry - including racism, sexism, ableism, homophobia, transphobia, or xenophobia. Code of Conduct.
Be respectful, especially when disagreeing. Everyone should feel welcome here.
No porn (NSFW prints are acceptable but must be marked NSFW)
No Ads / Spamming / Guerrilla Marketing
Do not create links to reddit
If you see an issue please flag it
No guns
No injury gore posts

If you need an easy way to host pictures, https://catbox.moe may be an option. Be ethical about what you post and donate if you are able or use this a lot. It is just an individual hosting content, not a company. The image embedding syntax for Lemmy is ![](URL)

Moderation policy: Light, mostly invisible

founded 2 years ago

MODERATORS

[email protected]

What is the deal with all this first layer fixation? (self.3dprinting)

submitted 1 week ago by drexy_rexy to c/[email protected]

22 comments fedilink hide all child comments

It seems like over the last couple months/half year there's been this new fixation with printing a huge perfect single layer of plastic all cross the entire bed of one's printer. I see lots of folks asking about calibration issues when they are trying to do this. It seems like it's sorta become a standard of sorts.

I just ask why?

It seems to use a huge amount of plastic and honestly I don't think it probably effects real world results that much.

I feel like the 3d printing community has a lot of shilling going on for companies and the information you get might not be entirely reliable. Look into the issues with this FLSUN S1 if you want to know what I mean.

But anyway, I have never had an impulse or see the need to print a single layer across the entire build surface of my printer. because I feel like that's a huge waste and doesn't actually matter when it comes to real world results.

Am I missing something? I kinda wonder if this kinda test is being pushed by the folks selling us filament, to sell us more filament. Is there a good reason to actually do this?

Please enlighten me!

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 1 week ago

Its just a test to dial your printer in. I shimmed my bed with 0.1mm washers. I haven't done a full square of plastic, but I printed my first layer / z-offset print of choice in all 4 corners and center in order to verify the bed level results in octoprint were accurate.

Before hand 70% of my bed printed perfect, but one spot was a little lower, and the mesh bed leveling wasn't accounting enough for it. Parts printed on textured sheets would not pick up the texture as well in that one spot. I like the textured look for top surfaces of control panels and such, so having an area on the bed that wouldn't apply the texture was a bit annoying.

Tests like what you are talking about is an extreme way to verify that everything is square, or at least well accounted for in the firmware.

Also, since this wasn't something achievable out of the box until recently, printer manufacturers are showing it off as a point of pride / as a sales tactic.