this post was submitted on 20 May 2024
674 points (98.4% liked)

Cool Guides

4736 readers
1 users here now

Rules for Posting Guides on Our Community

1. Defining a Guide Guides are comprehensive reference materials, how-tos, or comparison tables. A guide must be well-organized both in content and layout. Information should be easily accessible without unnecessary navigation. Guides can include flowcharts, step-by-step instructions, or visual references that compare different elements side by side.

2. Infographic Guidelines Infographics are permitted if they are educational and informative. They should aim to convey complex information visually and clearly. However, infographics that primarily serve as visual essays without structured guidance will be subject to removal.

3. Grey Area Moderators may use discretion when deciding to remove posts. If in doubt, message us or use downvotes for content you find inappropriate.

4. Source Attribution If you know the original source of a guide, share it in the comments to credit the creators.

5. Diverse Content To keep our community engaging, avoid saturating the feed with similar topics. Excessive posts on a single topic may be moderated to maintain diversity.

6. Verify in Comments Always check the comments for additional insights or corrections. Moderators rely on community expertise for accuracy.

Community Guidelines

By following these rules, we can maintain a diverse and informative community. If you have any questions or concerns, feel free to reach out to the moderators. Thank you for contributing responsibly!

founded 2 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
[–] [email protected] 2 points 7 months ago (1 children)

Additionally:

  • What do I do if solder doesn't stick to contact points?
  • What to do if there are plastic parts in contact with pad, like a button, or there's wire insulation that starts to melt before the solder does?
  • How do I clean the tip if I accidentally poked it into plastic?
  • How do I detach a part that has bent pins inside the solder layer?
  • What does flux do, exactly?
  • What's the difference between liquid flux and flux-core solder?
  • How do I prevent oxidation from occurring on copper wires?
  • How hot does the iron needs to be?
  • Do I need a heat gun?
  • How do I hold the wire, iron, solder and the board if I only have two hands?
[–] [email protected] 2 points 7 months ago (1 children)

How do I hold the wire, iron, solder and the board if I only have two hands?

This! I found a nice set of "helping hands" and they're.. really helpful!

[–] [email protected] 2 points 7 months ago (1 children)

Which brand are you using? I've tried a couple generic sets, but they were so light that I could topple them over by just blowing really hard.

[–] [email protected] 3 points 7 months ago (1 children)

KOTTO brand with magnetic base. The arms and base are very sturdy.

[–] [email protected] 2 points 7 months ago

It does indeed look pretty sturdy and ergonomic. Thanks! I'll definitely order one when I'll be able to receive shippings again.