Luthier

204 readers

1 users here now

Dedicated to the craft of lutherie, the making of string instruments, and all those who practice it, admire it, or wish to learn about it.

founded 1 year ago

MODERATORS

[email protected]

How wide to make channels in nut compared to strings? (lemmy.ca)

submitted 4 months ago* (last edited 4 months ago) by [email protected] to c/[email protected]

6 comments fedilink hide all child comments

Hi, 3d printing a nut guy again. Finally have all the materials and I think enough skill to model this thing on my own.

Exactly what tolerances should I have in the channels of the nut for the strings? Like, for example my low B string is a .59. How large should I make that channel? 1.50mm? A little more room perhaps?

Thanks for any responses!

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 5 points 4 months ago (1 children)

The cuts in the nut really serve two purposes:

Supposing there's no 0-fret, they let you set the action height at the headstock end of the fretboard.
Set string spacing at the headstock side.

So, in my opinion, try to keep the tolerances close but with a bit of room for movement. You want to be sure that the strings can slide when tuning and fretting notes without getting caught, which can mess with tuning. Especially with a floating bridge.

[–] [email protected] 3 points 4 months ago

Especially with a floating bridge.

Luckily it's a string through hard bridge. Ibanez ax7221 (Japanese built version.) I am going to be printing it standing up so that the layers of the print are parallel to the strings to keep it from getting hung up on the winds.