CyberDeck

262 readers

1 users here now

Hey y'all, just an experiment, if it works out I'll clean it up and run it

founded 2 years ago

MODERATORS

[email protected]

Any recommendations for Pi 5 battery power? (lemmy.world)

submitted 10 months ago by [email protected] to c/[email protected]

2 comments fedilink hide all child comments

Has anyone here done any experiments yet to see what works? I'll get a pi 5 in the mail in the next week, hopefully, and will be trying a couple setups to see what gives voltage warnings and whatnot...

Amp Ripper 4k and 1s pack
4s pack with separate charger and buck converter for the pi.

The buck converter route might work better on the pi5 than previous boards because of it's built in power on/off/suspend controls.

top 2 comments

sorted by: hot top controversial new old

[–] [email protected] 1 points 10 months ago* (last edited 10 months ago) (1 children)

I've always had better luck supplying 5.2v via the 5v pins on the header than I have using the Pi Foundation's PMIC. I'm really looking forward to seeing if they've improved it this time.

[–] [email protected] 1 points 10 months ago

I haven't used the header pins much, but there are two solder pads under the USB power plug that I like to solder 5v wires to directly. Same for the USB data pads for any USB devices that go inside the case.