homeassistant

11878 readers

1 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 1 year ago

MODERATORS

[email protected]

Ikea switch firmware not updating (lemmy.world)

submitted 1 year ago by [email protected] to c/[email protected]

7 comments fedilink hide all child comments

So i got an ikea on/off switch, i i have it connected via zigbee2mqtt, it says there is newer firmware, but when i try to update to it, it doesn't do anything, i tried pressing the buttons on it while updating, because the zigbee2mqtt documentation for the switch said that but it still doesn't update

all 11 comments

sorted by: hot top controversial new old

[+] [email protected] 2 points 1 year ago* (last edited 1 year ago) (1 children)

[deleted]

[–] [email protected] 1 points 1 year ago (1 children)

Here are my logs from what i can tell nothing is wrong in there it doesn't even give me a percentage

[–] [email protected] 2 points 1 year ago (3 children)

In those logs it states 'available' as if the update if found but not triggered. Did you send a manual trigger message like described here in the docs? Neither is "Device didn't respond to OTA request" in the log, further suggesting that. Sadly the file is cut off in your screenshot though so it's hard to tell. Could you upload and share the complete log?

[–] [email protected] 1 points 1 year ago

Here are my Z2M logs

[–] [email protected] 1 points 1 year ago

I went in to the Z2M OTA menu and it had an update(i just got the switch) and it just didn't show anything about it updating even after a while, so I pressed it again and it just said that it was already updating, so i waited a while more and still nothing pressed it again and it didn't say anything so I waited a bit and then restarted home assistant, but it was just the same, i dont know how to send a manual trigger message, and didn't see anything about it when i skimmed the link you sent, i dont know how to upload the logs

[–] [email protected] 1 points 1 year ago* (last edited 1 year ago)

I just updated my on/off switches and fyrtur shades last week (also running on a Pi). For the switches, I clicked a button on them yo make sure they were awake and then ran to my computer to initiate the update immediately and it worked. The "update initiated pass/fail" message should appear in a small pop-up card on the upper right of the Z2M window before disappearing a few seconds later.

What I haven't been able to update is the open/close switches no matter what I've tried.