Coffee

8376 readers

1 users here now

☕ - The hot beverage that powers the world!

Coffee gadgets - It's always great to learn about new gadgets. Please share your favorite hardware or full setups. It might inspire newcomers to experiment!

Local businesses - Please promote your local businesses. If you are not the owner of the business you are promoting, kindly ask the owner if it's okay. It would be great if the business has a physical store to include an exterior or interior shot.

founded 1 year ago

MODERATORS

[email protected]

Coffee syphon struggles (lemmy.world)

submitted 1 year ago by [email protected] to c/[email protected]

5 comments fedilink hide all child comments

I've been using my coffee syphon for a year+ now. It became a ritual for me and it makes a good cup. The past month or so I've run into a problem that I can't find any answers to, hoping someone here has seen this.

When I remove the syphon from the lamp, it will draw down about half way then stop. The rest of the coffee is sitting up top refusing to come down. The pressure doesn't release as quickly as it used to, but I think something else is the problem.

I've stirred to ensure the grinds aren't blocking
I've pried the two chambers apart - I can hear the pressure release, this itself doesn't solve it either
I've dumped the contents of the top to another container and cleaned out the grinds then added it back, it still sits up top

The only thing I can think of is the filter, but some of the coffee can go through.

Using the Hario NXA-5 and Yuchengtech lamp.

you are viewing a single comment's thread
view the rest of the comments

[–] [email protected] 2 points 1 year ago (4 children)

What you describe sounds exactly like a partially clogged filter. If you're using a metal screen filter, try giving it a thorough scrub and wash with dish soap.

Note that stirring can actually make the "grinds blocking" effect worse rather than better in some setups.

[–] [email protected] 1 points 1 year ago (1 children)

Just getting around to updating. Clogged filter. The cloth looks clean enough but go figure. Swapped in the metal one and back to an immediate draw after removing from the heat. Thanks for the assist on this, could have sworn I did that ages ago.

[–] [email protected] 0 points 1 year ago

That's great news, I'm glad it worked out!

load more comments (2 replies)